It's
hard on the starter or the engine will not turn often a problem for
one's own car, especially if it turns out the owner had no clue how to
treat the car. Do
not let you be one among them who are blind technology, because death
is not rare in the machine when you least expect it (eg before an
important meeting). For that, consider the following tips.
The first thing to note is that the car electrical system, conventional or modern cars are already using CDI (in the sense of all-electronic). If your car has been using all-electronic system, do not try to fix it manually because the system requires a reliable mechanic and equipment only
in car garages.
Usually there are two things that cause a car to the starter, the first is that the battery is in good condition less electrical system. The second is due to supply electricity to the armature in a conventional ignition system. Platinum may be not good. If the technology is more advanced, perhaps because of CDI. Kalou already CDI problem, perluke workshop because already complicated and difficult to handle alone. On the upper surface of the battery there are indicators that show the last condition of the battery. Can nunjukkin good battery condition / damaged, or an empty battery water.
If already checked but the car still can not be turned on, it could be caused by platinum and the condenser. Problems are usually contained in the platinum plate. If bulge was dull mean mean it can not capture the spark of electricity. Platinum in order to return to function properly, use sandpaper to remove dust / spots that stick. When you're done, plug it back in its original position. Platinum that has been cleaned normally be able to provoke return fire so big, if not, it means that platinum is not used and must be replaced.
The next step is to check the fuse box. Note that if a fuse has been installed is still intact or not. If wire connection is broken, then the fuse must be replaced. For emergencies, you can use a wire or fiber cable to be installed while the fuse. It is not recommended as a permanent solution, because it is changing quickly with the car to the garage.
The last thing that used to be the ringleader of a car engine can not be a starter is because the supply of fuel / air is lacking in the carburetor system (in this case means the filter dirty carburetor). Check the filter, remove the filter and clean with a brush or toothbrush. Do not use a heater such as a hair-dryer and the like, because it can damage the walls of the air filter.
When everything is done and no progress could be none, take your car to the nearest garage. Do-do, not just in battery damage or platinum you.
The first thing to note is that the car electrical system, conventional or modern cars are already using CDI (in the sense of all-electronic). If your car has been using all-electronic system, do not try to fix it manually because the system requires a reliable mechanic and equipment only
in car garages.
Usually there are two things that cause a car to the starter, the first is that the battery is in good condition less electrical system. The second is due to supply electricity to the armature in a conventional ignition system. Platinum may be not good. If the technology is more advanced, perhaps because of CDI. Kalou already CDI problem, perluke workshop because already complicated and difficult to handle alone. On the upper surface of the battery there are indicators that show the last condition of the battery. Can nunjukkin good battery condition / damaged, or an empty battery water.
If already checked but the car still can not be turned on, it could be caused by platinum and the condenser. Problems are usually contained in the platinum plate. If bulge was dull mean mean it can not capture the spark of electricity. Platinum in order to return to function properly, use sandpaper to remove dust / spots that stick. When you're done, plug it back in its original position. Platinum that has been cleaned normally be able to provoke return fire so big, if not, it means that platinum is not used and must be replaced.
The next step is to check the fuse box. Note that if a fuse has been installed is still intact or not. If wire connection is broken, then the fuse must be replaced. For emergencies, you can use a wire or fiber cable to be installed while the fuse. It is not recommended as a permanent solution, because it is changing quickly with the car to the garage.
The last thing that used to be the ringleader of a car engine can not be a starter is because the supply of fuel / air is lacking in the carburetor system (in this case means the filter dirty carburetor). Check the filter, remove the filter and clean with a brush or toothbrush. Do not use a heater such as a hair-dryer and the like, because it can damage the walls of the air filter.
When everything is done and no progress could be none, take your car to the nearest garage. Do-do, not just in battery damage or platinum you.
Tidak ada komentar:
Posting Komentar