AC in a four-wheeled vehicles, is slowly becoming a necessity. And function also can not be compromised again. hence if the car air conditioner did not work properly sometimes so completely wrong crew vehicle. When the glass is opened into the dust and fumes. While if it is closed, it will attack the musty flavor.
So to overcome the obstacles mentioned, there are short tips that can be done about it as an alternative before your vehicle checked at the hands of experts. Previously there may be a number of disorders that can arise until the AC function can not work optimally. Disorders of the AC evaporator is usually due to clogged exhaust themselves and their causes are:
Squeezed or twisted rubber channel. Waste water will turn up, when full of water would overflow the channel and separated from the outlet channel has been completed despite the clamp. Gagged dirt. Exhaust can be gagged mud because the ends of these channels are under the car. Channel is separated from the evaporator outlet pipe.
Now to deal with is as follows:
1. Prepare a Phillips screwdriver (+), and open the cover of the main pillars Right and left are usually colored to match the interior.
So to overcome the obstacles mentioned, there are short tips that can be done about it as an alternative before your vehicle checked at the hands of experts. Previously there may be a number of disorders that can arise until the AC function can not work optimally. Disorders of the AC evaporator is usually due to clogged exhaust themselves and their causes are:
Squeezed or twisted rubber channel. Waste water will turn up, when full of water would overflow the channel and separated from the outlet channel has been completed despite the clamp. Gagged dirt. Exhaust can be gagged mud because the ends of these channels are under the car. Channel is separated from the evaporator outlet pipe.
Now to deal with is as follows:
1. Prepare a Phillips screwdriver (+), and open the cover of the main pillars Right and left are usually colored to match the interior.
2. Open the right and left AC with a screwdriver. then off AC switch cover with 2 screws to open. Then remove 8 screws holding the cover and 4 channels incoming and exhaust blower.
3. Open 13 screw cap bottom blower, do this carefully and do not be forced to pull out now.
4. Check and clean the lid with a dry cloth. observe hose being pinched, twisted or loose, then correct the position until no longer an interruption.
5.Make sure the compressor hose ends clean of debris. Then the chain back all components carefully.
So easy is not it ...? Good luck
Tidak ada komentar:
Posting Komentar